HP E4510-48G, Command Reference Manual

Page: 366 / 1334

12-10
You can use the reset ipv6 neighbors command to clear specific IPv6 neighbor information.
Related commands: ipv6 neighbor , reset ipv6 neighbors .
Examples
# Display all neighbor information.
<Sysname> display ipv6 neighbors all
Type: S-Static D-Dynamic
IPv6 Address Link-layer VID Interface State T Age
FE80::200:5EFF:FE32:B800 0000-5e32-b800 N/A GE1/0/1 REACH S -
Table 12-7 display ipv6 neighbors command output description
Field Description
IPv6 Address IPv6 address of a neighbor
Link-layer Link layer address (MAC address of a neighbor)
VID VLAN to which the interface connected with a neighbor belongs
Interface Interface connected with a neighbor
State
State of a neighbor, including:
z
INCMP: The address is being resolved. The link layer address of the
neighbor is unknown.
z
REACH: The neighbor is reachable.
z
STALE: The reachability of the neighbor is unknown. The device will
not verify the reachability any longer unless data is sent to the
neighbor.
z
DELAY: The reachability of the neighbor is unknown. The device
sends an NS message after a delay.
z
PROBE: The reachability of the neighbor is unknown. The device
sends an NS message to verify the reachability of the neighbor.
T
Type of neighbor information, including static configuration and dynamic
acquisition.
Age
For a static entry, a hyphen “-“ is displayed. For a dynamic entry, the
reachable time (in seconds) elapsed is displayed, and if it is never
reachable, “#” is displayed (for a neighbor acquired dynamically).
display ipv6 neighbors count
Syntax
display ipv6 neighbors { { all | dynamic | static } [ slot slot-number ] | interface interface-type
interface-number | vlan vlan-id } count
View
Any view
Default Level
1: Monitor level