HP E4510-48G, Command Reference Manual

Page: 404 / 1334

13-4
undo sflow enable { inbound | outbound }
View
Ethernet port view
Default Level
2: System level
Parameters
inbound : Samples inbound packets.
outbound : Samples outbound packets.
Description
Use the sflow enable command to enable sFlow in the inbound or outbound direction on the port.
Use the undo sflow enable command to disable sFlow in the inbound or outbound direction on the
port.
sFlow is disabled by default.
Note that:
This command is supported on physical Ethernet interfaces only, instead of logical interfaces (VLAN
interfaces). If you want to enable sFlow on an aggregation group, you need to enable sFlow on each
member port.
Examples
# Enable sFlow in the outbound direction on GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface GigabitEthernet 1/0/1
[Sysname-GigabitEthernet1/0/1] sflow enable outbound
sflow interval
Syntax
sflow interval interval-time
undo sflow interval
View
System view
Default Level
2: System level
Parameters
interval-time : Counter sampling interval in seconds, in the range 2 to 200.
Description
Use the sflow interval command to set the counter sampling interval at which the sFlow agent collects
the statistics of all sFlow enabled ports.