6-1
6
Route Policy Configuration Commands
The common configuration commands of route policy are applicable to both IPv4 and IPv6.
Common Route Policy Configuration Commands
apply cost
Syntax
apply cost
[
+
|
-
]
value
undo apply cost
View
Route policy view
Default Level
2: System level
Parameters
+
: Increases a cost value.
+
: Decreases a cost value.
cost
: Cost in the range 0 to 4294967295.
Description
Use the
apply cost
command to set a cost for routing information.
Use the
undo apply cost
command to remove the clause configuration.
No cost is set for routing information by default.
Related commands:
if-match interface
,
if-match acl
,
if-match ip-prefix
,
if-match ip next-hop
,
if-match cost
,
if-match tag
,
route-policy
,
apply ip-address next-hop
,
apply tag
.
Examples
# Configure node 10 in permit mode of route policy
policy1
: set a cost of 120 for routing information
whose outbound interface is Vlan-interface 10.
<Sysname> system-view
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy] if-match interface Vlan-interface 10
Summary of Contents for E4510-48G
