HP E4510-48G, Command Reference Manual

Page: 446 / 1334

3-12
Default Level
2: System level
Parameters
protocol : Specifies a routing protocol from which to redistribute routes. At present, it can be direct , rip ,
or static .
process-id : Process ID, in the range of 1 to 65535. The default is 1. It is available only when the
protocol is rip .
all-processes : Enables route redistribution from all the processes of a protocol. This keyword takes
effect only when the protocol is rip .
cost : Cost for redistributed routes, in the range of 0 to 16. If cost is not specified, the default cost
specified by the default cost command applies.
tag : Tag marking redistributed routes, in the range of 0 to 65,535. The default is 0.
route-policy route-policy-name : Specifies a routing policy with 1 to 19 characters.
Description
Use the import-route command to enable route redistribution from another routing protocol.
Use the undo import-route command to disable route redistribution.
By default, RIP does not redistribute routes from other routing protocols.
Note that:
z
Only active routes can be redistributed. You can use the display ip routing-table protocol
command to display route state information.
z
You can specify a routing policy using the keyword route-policy to redistribute only the specified
routes.
z
You can configure a cost for redistributed routes using the keyword cost .
z
You can configure a tag value for redistributed routes using the keyword tag .
Related commands: default cost .
Examples
# Redistribute static routes, and set the cost to 4.
<Sysname> system-view
[Sysname] rip 1
[Sysname-rip-1] import-route static cost 4
# Configure the default cost for redistributed routes to 3.
[Sysname-rip-1] default cost 3
network
Syntax
network network-address
undo network network-address
View
RIP view