HP E4510-48G, Command Reference Manual

Page: 688 / 1334

3-14
Description
Use the secondary authorization command to specify the secondary HWTACACS authorization
server.
Use the undo secondary authorization command to remove the configuration.
By default, no secondary HWTACACS authorization server is specified.
Note that:
z
The IP addresses of the primary and secondary authorization servers cannot be the same.
Otherwise, the configuration fails.
z
The HWTACACS service port configured on the device and that of the HWTACACS server must
be consistent.
z
If you configure the command for more than one time, the last configuration takes effect.
z
You can remove an authorization server only when no active TCP connection for sending
authorization packets is using it.
Related commands: display hwtacacs .
Examples
# Configure the secondary authorization server.
<Sysname> system-view
[Sysname] hwtacacs scheme hwt1
[Sysname-hwtacacs-hwt1] secondary authorization 10.163.155.13 49
stop-accounting-buffer enable (HWTACACS scheme view)
Syntax
stop-accounting-buffer enable
undo stop-accounting-buffer enable
View
HWTACACS scheme view
Default Level
2: System level
Parameters
None
Description
Use the stop-accounting-buffer enable command to enable the device to buffer stop-accounting
requests getting no responses.
Use the undo stop-accounting-buffer enable command to disable the device from buffering
stop-accounting requests getting no responses.
By default, the device is enabled to buffer stop-accounting requests getting no responses.
Since stop-accounting requests affect the charge to users, a NAS must make its best effort to send
every stop-accounting request to the HWTACACS accounting servers. For each stop-accounting
request getting no response in the specified period of time, the NAS buffers and resends the packet