HP E4510-48G, Command Reference Manual

Page: 852 / 1334

14-33
Parameters
frequence : Interval in minutes for packet filtering statistics. It must be an integer in the range of 0 to
1440 and a multiple of five.
Description
Use the acl ipv6 logging frequence command to set the interval for IPv6 packet filtering statistics. At
the specified interval, the device outputs the statistics information, including the number of filtered
packets, and the ACL rules used.
Use the undo ipv6 acl logging frequence command to restore the default.
By default, the interval is 0, that is, no IPv6 packet filtering statistics is collected.
Example
# Set the interval for IPv6 packet filtering statistics to 15 minutes.
<Sysname> system-view
[Sysname] acl ipv6 logging frequence 15
packet-filter
Syntax
packet-filter { acl-number | name acl-name } { inbound | outbound }
undo packet-filter { acl-number | name acl-name } { inbound | outbound }
View
Ethernet interface view, VLAN interface view
Default Level
2: System level
Parameters
acl-number : Specifies the number of an ACL, which must be in the following ranges:
z
2000 to 2999 for basic IPv4 ACLs
z
3000 to 3999 for advanced IPv4 ACLs
z
4000 to 4999 for Ethernet frame header ACLs
name acl-name : Specifies the name of the ACL, which is a case insensitive string of 1 to 32 characters.
It must start with an English letter and cannot be the English word of all to avoid confusion.
inbound : Specifies to filter the packets received by the interface.
outbound : Specifies to filter the packets that are to be sent out of the interface.
Description
Use the packet-filter command to apply an ACL to an interface to filter IPv4 packets or Ethernet
frames.
Use the undo packet-filter command to restore the default.
By default, an interface does not filter packets and Ethernet frames.