HP E4510-48G, Command Reference Manual

Page: 687 / 1334

3-13
Default Level
2: System level
Parameters
ip-address : IP address of the server, a valid unicast address in dotted decimal notation. The default is
0.0.0.0.
port-number : Port number of the server. It ranges from 1 to 65535 and defaults to 49.
Description
Use the secondary authentication command to specify the secondary HWTACACS authentication
server.
Use the undo secondary authentication command to remove the configuration.
By default, no secondary HWTACACS authentication server is specified.
Note that:
z
The IP addresses of the primary and secondary authentication servers cannot be the same.
Otherwise, the configuration fails.
z
The HWTACACS service port configured on the device and that of the HWTACACS server must
be consistent.
z
If you configure the command for more than one time, the last configuration takes effect.
z
You can remove an authentication server only when no active TCP connection for sending
authentication packets is using it.
Related commands: display hwtacacs .
Examples
# Specify the secondary authentication server.
<Sysname> system-view
[Sysname] hwtacacs scheme hwt1
[Sysname-hwtacacs-hwt1] secondary authentication 10.163.155.13 49
secondary authorization
Syntax
secondary authorization ip-address [ port-number ]
undo secondary authorization
View
HWTACACS scheme view
Default Level
2: System level
Parameters
ip-address : IP address of the server, a valid unicast address in dotted decimal notation. The default is
0.0.0.0.
port-number : Port number of the server. It ranges from 1 to 65535 and defaults to 49.