HP E4510-48G, Command Reference Manual

Page: 879 / 1334

3-9
Field Description
Protected VLAN
List of VLANs protected by the RRPP domain. MSTIs are displayed
here. To get the VLANs corresponding to these MSTIs, use the
display stp region-configuration command.
Hello Timer Hello Timer value in seconds
Fail Timer Fail Timer value in seconds
Ring ID RRPP ring ID
Ring Level
RRPP ring level:
z
0 representing primary ring
z
1 representing subring
Node Mode
Node mode:
z
Master node
z
Transit node
z
Edge node
z
Assistant edge node
Ring State
RRPP ring state. This field makes sense only when the node mode
field is master node.
z
“Complete” appears when the ring is in health state;
z
“Failed” appears when the ring is in disconnect sate;
z
“–” appears in all the other cases.
Enable Status
RRPP ring enable status
z
Yes for enabled
z
No for disabled
Active Status
RRPP ring activation status. An RRPP ring can be active only when
the RRPP protocol and the RRPP ring are both enabled. Therefore,
you can also use this field to identify whether the RRPP protocol are
enabled. Two statuses are available:
z
Yes for active
z
No for inactive
Primary Port
The primary port field means the node mode is master node or
transit node. “-“ appears when the port is not configured on the ring
or the board to which the port belongs does not start.
Secondary Port
The secondary port field means the node mode is master node or
transit node.
- appears when the port is not configured on the ring or
the board to which the port belongs does not start.
Common Port
The common port field means the node mode is edge node or
assistant edge node. “-“ appears when the port is not configured on
the ring or the board to which the port belongs does not start.
Edge Port
The edge port field means the node mode is edge node or assistant
edge node. “-“ appears when the port is not configured on the ring
or the board to which the port belongs does not start.
Port status
Port status includes down, up and blocked; “-“ appears in one of the
following cases:
z
the ring is inactive
z
the port is not configured on the ring
z
the board to which the port belongs does not start