HP E4510-48G, Command Reference Manual

Page: 476 / 1334

5-11
ripng default-route
Syntax
ripng default-route { only | originate } [ cost cost ]
undo ripng default-route
View
Interface view
Default Level
2: System level
Parameters
only : Indicates that only the IPv6 default route (::/0) is advertised through the interface.
originate : Indicates that the IPv6 default route (::/0) is advertised without suppressing other routes.
cost : Metric of the advertised default route, in the range of 1 to 15, with a default value of 1.
Description
Use the ripng default-route command to advertise a default route with the specified routing metric to
a RIPng neighbor.
Use the undo ripng default-route command to stop advertising or forwarding the default route.
By default, a RIP process does not advertise any default route.
After you execute this command, the generated RIPng default route is advertised in a route update
over the specified interface. This IPv6 default route is advertised without considering whether it already
exists in the local IPv6 routing table.
Examples
# Advertise only the default route through VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ripng default-route only
# Advertise the default route together with other routes through VLAN-interface 101.
<Sysname> system-view
[Sysname] interface vlan-interface 101
[Sysname-Vlan-interface101] ripng default-route originate
ripng enable
Syntax
ripng process-id enable
undo ripng enable
View
Interface view