HP E4510-48G, Command Reference Manual

Page: 993 / 1334

3-15
CTRL_V Paste text from the clipboard.
CTRL_W Delete the word left of the cursor.
CTRL_X Delete all characters up to the cursor.
CTRL_Y Delete all characters after the cursor.
CTRL_Z Return to the User View.
CTRL_] Kill incoming connection or redirect connection.
ESC_B Move the cursor one word back.
ESC_D Delete remainder of word.
ESC_F Move the cursor forward one word.
ESC_N Move the cursor down a line.
ESC_P Move the cursor up a line.
ESC_< Specify the beginning of clipboard.
ESC_> Specify the end of clipboard.
display this
Syntax
display this [ by-linenum ]
View
Any view
Default Level
1: Monitor level
Parameters
by-linenum : Specifies to display the number of each line.
Description
Use the display this command to display the validated configuration under the current view.
After finishing a set of configurations under a view, you can use the display this command to check
whether the configuration takes effect.
Note that:
z
A parameter is not displayed if it has the default configuration.
z
A parameter is not displayed if the configuration has not taken effect.
z
When you use the command in a user interface view, the command displays the valid
configuration in all the user interfaces.
z
When you use the command in a VLAN view, the command displays configurations of all created
VLANs.
Examples
# Display the valid configuration information of the current view (the output information depends on the
current configuration of the device).
<Sysname> system-view
[Sysname] user-interface vty 0
[Sysname-ui-vty0] display this
#