Furuno FCR-2107 series, Operator'S Manual

Page: 40 / 556

1. Operational Overview
1-18
1.13 Charts
S57 ENC ed. 3 vector charts or CM-93 vector charts may be used.
Chart loading and updating
Charts can be loaded and updated when the chart radar mode is in use. For more information about how to load and
update charts, see Chapter 7 Vector Chart Material.
1.14 Route Monitor
A route created by ECDIS can be overlaid on the radar and chart radar pictures. There are two ways to display the
route in this modes:
- Stand-alone mode: Use ECDIS mode-created route
- Route share mode: Use ECDIS route received via an ECDIS unit connected to the network
Stand-alone mode
1. Use the trackball to select the Route selection box at the upper part of the display.
Route: Not selected (Route selection box)
2. Spin the scrollwheel to select desired route for monitoring. Route planning must be done in the ECDIS
mode.
For more information about route planning and monitoring, see Chapter 10 Route Planning and Chapter 11 Route
Monitoring.
Route share mode
Route cannot be created in this mode. Further, route to monitor cannot be selected. ECDIS mode created route is
displayed however it cannot be selected for monitoring. On an ECDIS unit connected to the network, open the route
from Plan Route. Select Exchange with monitored from the menu, or open the route directly with Monitor route.
Then, the route is displayed on the ECDIS screen as well as radar and chart radar.
Note: To receive route information from an ECDIS unit in the network, that ECDIS must be set up to transfer route
information. For further details, contact your dealer.