Fujitsu AIRSTAGE V-II, Design & Technical Data

Page: 561 / 711

COMPLETION OF ADDRESS SETTING MODE
„ „
SETTING UP EACH INDOOR UNIT
„ „
RESET THE POWER AFTER SETTING UP ADDRESS OF ALL
„ „
INDOOR UNITS
Important
If the reset is not performed, address can not be read in normally6 *
After all the addresses have been set, the circuit breaker needs to be switched off *
for at least 2 minutes6
After the 2 minutes has passed, power can be restored6
The set address is stored in the PCB and will remain in memory even when the *
power is turned off6
However setting address is effective after power reset6
Record the address set in the indoor unit on a label, etc., and affix the label to the
unit so it can be used for after6sales service operations6
To clear the address setting mode and return to the regular display, hold down the 13)
three buttons of SET TEMP. V, SET TEMP. Λ and FAN at the same time.
Normal mode display
If no key entry is made for 60 seconds, even though none of the above buttons is *
pressed, the address setting mode will automatically be cleared.
(If the address setting mode is automatically cleared while setting addresses,
activate the mode again according to the procedure in step 4) above.)
00 01 01 01 02 01 13 01 14 01 15 01 0 1 2 0 1 0
Indoor unit Indoor unit Indoor unit Indoor unit Indoor unit Indoor unit
Repeat the procedures in steps 1) through 13), and set up the indoor units
requiring address setting.
Wired remote
controller
Wired remote
controller
Wired remote
controller
- (06 - 89) -
SY
ST
EM
DE
SIGN
SY
ST
EM
DE
SIGN