Fujitsu AIRSTAGE V-II, Design & Technical Data

Page: 568 / 711

SIGNAL AMPLIFIER AUTOMATIC ADDRESS SETTING
„ „
After verifying that the system is normally, press the MODE/EXIT button (SW107) once. 1)
Press the SELECT button (SW108) to display “F3” on the LED104. 2 )
*1 : The “F1” and “F9” modes are used for maintenance, so do not set them in regular
When “F3” appears on the LED104, press the ENTER button (SW109). 3)
A flashing display appears on the LED105.
Press the SELECT button (SW108) to display “10” on the LED105.
4)
When “10” appears on the LED105, hold down the ENTER button (SW109) for at least 3 5)
seconds. (Unless it is held down for at least 3 seconds, the selection will not be confirmed.)
When the Automatic Address Setting function is activated, the display changes to “run.”
When automatic address setting is completed, the number of signal amplifier is displayed on 6)
the LED104. Verify that the count matches the number of signal amplifiers being installed.
Ex.) When eight signal amplifiers are being connected
To exit automatic address setting, press the ENTER button (SW109) in the setting completed
7)
status shown in step 6) above.
Next, press the MODE/EXIT button (SW107) to exit the Function mode.
Caution
The Signal Amplifier Automatic Address Setting function can be used for a maximum of eight ●
signal amplifiers installed within the same network.
Perform the automatic address setting of signal amplifiers on only one outdoor unit (master unit) ●
within the same network. (Do not set them again from other outdoor unit.)
When setting the address of a signal amplifier automatically, be sure to always set the address on
●
the printed circuit board of the Signal amplifier to “1”(factory setting).
(The display of the LED104 changes each time the SELECT button is pressed.)
LED105 LED104 LED105 LED104 LED105 LED104 LED105 LED104
*1 *1
(Monitoring mode) (Setting mode) (Function mode) (Error history mode)
LED105 LED104
LED105 LED104
LED105 LED104 LED105 LED104
LED105 LED104 LED105 LED104
LED105 LED104 LED105 LED104
LED105 LED104
LED105 LED104
LED105 LED104 LED105 LED104
LED105 LED104
LED105 LED104
- (06 - 96) -
SY
ST
EM
DE
SIGN
SY
ST
EM
DE
SIGN