Fujitsu AIRSTAGE V-II, Design & Technical Data

Page: 588 / 711

FUNCTION SETTING
„ „
(6) Press the “MODE” button to access the
function setting mode.
(7) Press the “
p
” or the “
q
” buttons to
select the function number.
Each time the “MODE” button is pressed, it
switches between 1 unit and 10 units positions.
(8) Press the FAN button to proceed to setting
the number. (Press the FAN button again
to return to the function number selection.)
(9) Press the “
p
” or the “
q
” buttons to select
the setting number.
Each time the “MODE” button is pressed, it
switches between 1 unit and 10 units positions.
(10) Press the “START/STOP” button once to
send the information. A beeping noise will
be heard if the command is accepted.
In the following cases the setting signal is not read

and a buzzer sounds.
The function setting No. is set out of range
: Pi Pi Pi Pi Pi
(11) Indoor unit will display the function setting
number on "OPERATION"(GREEN),
"TIMER "(ORANGE) and "FILTER
"(RED) light.
Number 0 setting will not indicate TIMER LAMP and

FILTER LAMP.
Confirmation of function setting
„ z
(12) Press the “TIMER set (+)” button.
Change degit
Change degit
Pi Pi
Pi PiPiPi
OPERATION
(GREEN)
TIMER
(ORANGE)
Flashing times of
function numbers
(10 digit)
FILTER
(RED)
Flashing times of
function numbers
(1 digit)
Flashing times of
setting numbers
(1 digit)
(Example) Function number : 30, Setting number : 06
OPERATION LAMP
(GREEN)
TIMER LAMP
(ORANGE)
FILTER LAMP
(RED)
0.5sec ON / 0.5sec OFF
OFF
1 time
3 times
1 - 10 sec
1 - 10 sec
0.5sec ON / 0.5sec OFF
“TIMER set (+)”
PiPi
CORRECT : Pi PiPiPiPiPi
PiPi
WRONG: Pi (3 sec)
- (06 - 116) -
SY
ST
EM
DE
SIGN
SY
ST
EM
DE
SIGN