Fujitsu AIRSTAGE V-II, Design & Technical Data

Page: 235 / 711

When there is an obstruction above the product, observe the minimum installation height
„
●
and install an outlet duct as shown in the figure.
When an outlet duct, etc. is installed; the high static pressure mode must be set by
„
●
pushbutton switch.
(Also applies when a snow hood was installed)
High static pressure mode setting
„ z
Select the high static pressure mode in accordance with the table below.
Condition High static pressure mode setting *1
When L≤ 150mm and there is no other
resistance at the outlet (30Pa or less)
Set to Mode 1
When L>150mm, or there is no other
resistance at the outlet (80Pa or less)
Set to Mode 2
*1 : Refer to the section on Push Switch Setting in "6-6.FUNCTION SETTING".
When an outlet duct is not installed, install the product as shown below3
„ z
1) Make the ceiling height after setting 1m or greater.
2) Be sure there is no wall at the rear side.
3) When installing products adjacently, install up to 3 units.
333333 WHEN THERE IS AN OBSTRUCTION ABOVE THE PRODUCT
L
500mm
or more
Outlet
duct
1000mm
or more
500mm
or more
front rear
- (03 - 28) -
OU
TD
OO
R
UN
IT
S
OU
TD
OO
R
UN
IT
S