Fujitsu AIRSTAGE V-II, Design & Technical Data

Page: 608 / 711

6666606 SIGNAL AMPLIFIER
SWITCH POSITION
„ „
AUTOMATIC ADDRESS SETTING
„ „
Refer to 6-5-7 ●
MANUAL ADDRESS SETTING
„ „
1) Turn on the power for the signal amplifier.
2) While holding down the set button (SW4), press and release the reset button (SW7) to enter
the address setting mode.
The address setting mode is activated only if the set button is hold down when the reset
button is released.
3) Press the set button (SW4) to display the current address.
The address is set to A1 at the factory.
*1 : When the automatic address setting is selected, the display range is 9 - 16.
4) Press the mode button (SW3) to select the address. *2
The displayed address changes as follows each time the mode button is pressed.
*2 : If connecting multiple signal amplifiers, be sure to select a different address for each amplifier.
If the same address is used for different signal amplifiers, communication cannot occur.
5) Press the set button (SW4) to set the selected address.
6) Turn the power off and on or press the reset button (SW7) to exit the address setting mode
and return to the normal mode.
If an address setting error occurs ("26" is displayed on the right side of the D19 LED
display), the address will not be set. Perform address setting again.
SW3 SW4
SW7
SW2
SW1
D19
D9
D14
D19
D19
D19
D19
A1 A2
A8 A3
A7 A4
A6 A5
*1
For automatic
address setting
D19
Ex.) Address No.5 is selected.
Normal mode
D19
Address setting error
D19
- (06 - 136) -
SY
ST
EM
DE
SIGN
SY
ST
EM
DE
SIGN