Fujitsu AIRSTAGE V-II, Design & Technical Data

Page: 555 / 711

COMPLETION OF ADDRESS SETTING MODE
„ „
(21) Press and hold the “MANUAL/AUTO ”
button for 3 seconds.
Each LED light brightness is darkening though the content

of the display doesn't change.
(22) Press the “RESET” button.
After pressing the RESET
button, please set the custom
code again if b,c,d setting.
The address setting signal is not received after switched address setting completion mode. (Pi Pi Pi Pi Pi)
„ 
Press the "MANUAL/AUTO " button again for 3 sec to return to if required to return the address
„ 
setting mode.
RECONFIRMATION OF ADDRESS SETTING
„ „
(23) Press and hold the “FAN” and the “ SET
TEMP.
p
” buttons. Whilst holding these 2
buttons, press the "RESET" button.
INDOOR UNIT ADDRESS SETTING
„ z
(24) Make sure the function number is "01"
Refer to (8)
Press the “TIMER set (-)” button.
REFRIGERANT CIRCUIT ADDRESS SETTING
„ z
(25) Make sure the function number is "02"
Refer to (15)
Press the “TIMER set (-)” button.
Pi Pi Pi
MANUAL
AUTO
MANUAL AUTO
IR RECEIVER UNIT
RESET
SET TEMP. ( )
RESET
FAN
Function setting
mode display
(Example) ADDRESS : 34
OPERATION LAMP
(GREEN)
TIMER LAMP
(ORANGE)
FILTER LAMP
(RED)
0.5sec ON / 0.5sec OFF
4 times
3 times 1 - 10 sec
1 - 10 sec
0.5sec ON / 0.5sec OFF
(Example) ADDRESS : 25
OPERATION LAMP
(GREEN)
TIMER LAMP
(ORANGE)
FILTER LAMP
(RED)
0.5sec ON / 0.5sec OFF
1sec ON / 1sec OFF
5 times
2 times 1 - 10 sec
1 - 10 sec
0.5sec ON / 0.5sec OFF
"TIMER set (-)"
"TIMER set (-)"
- (06 - 83) -
SY
ST
EM
DE
SIGN
SY
ST
EM
DE
SIGN