Fujitsu AIRSTAGE V-II, Design & Technical Data

Page: 609 / 711

6666666 NETWORK CONVERTOR FOR L
ON
W
ORKS®
SWITCH POSITION
„ „
ADDRESS SETTING
„ „
When setting address, please be sure that the address of Network Convertor is
not overlap the address of other controller like, Touch Panel Controller & Network
Convertor for Group Remote Controller6
Following steps are necessary for setting address of Network Convertor.
1) Turn on the power of network convertor.
2) Select the special mode by pressing and releasing SW7 (reset button) while holding down
SW4 (set button) until special mode “1” is displayed.
Special mode changes from ‘1’ to ‘4’ as shown in the above mentioned way.
3) Press SW3 (mode button) to set special mode “2”. Special mode “2” is the address setting
mode.
4) Press SW4 (set button). Present address is displayed.
5) Press SW3 (mode button) to select the address. The displayed address changes as follows
each time the mode button is pressed.
6) Press SW4 (set button) to set the selected address.
7) Turn the power off and on or press SW7 (reset button) to exit from address setting mode.
Anyone of the following indication will disappear:
: VRF Network address allocation is not registered by using Tool for Network Convertor
: Binding and Commissioning is not executed
: Normal Mode ( Ready for operation)
: Others (Please check Installation Manual for more detail)
SW3 SW4
JP1
SW7
SW2
SW1
D19
A01 A02 A00
A15
Ex.) Address No. 3 is selected.
Ex.) Address No. 3 is set.
Ex.) Address No. 15 is factory setting.
- (06 - 137) -
SY
ST
EM
DE
SIGN
SY
ST
EM
DE
SIGN