Fuji Xerox DocuPrint 5105 d, User Manual

Page: 295 / 419

6.9 Non-Genuine Mode
295
6.9 Non-Genuine Mode
A message appears to alert you when it is time to replace a toner cartridge or drum cartridge.
When you want to use the printer in Non-Genuine mode, use the following procedure to
configure the mode and install supported toner. Empty toner cartridges cannot be used even in
this mode.
Important
• The printer may not operate optimally if used in Non-Genuine mode. Also, any problems that arise from the use
of Non-Genuine mode are not covered by our quality guarantee. Continued use of the printer after a problem
occurs creates the risk of printer malfunction. You will be liable for repair charges from such malfunction.
• " [Drum Life End]" (P. 175) settings are ignored while in the Non-Genuine mode. Also, remaining toner cartridge
and drum cartridge levels are not displayed.
Note
• To disable the Non-Genuine mode, select [Off] in Step 4, below.
1. On the control panel, press the < > and <OK>
buttons at the same time.
This displays the [Consumables Menu].
2. Press the < > until [Non-Genuine] appears.
3. Press the < > or <OK> button to select.
This displays the current setting.
4. Press the < > so [On] is displayed.
5. Press the < > or <OK> button to apply the
selection.
This displays a confirmation screen.
6. Press the <OK> button.
This changes the settings to the Non-Genuine
mode settings.
7. Switch off the power and wait for about 10
seconds after the display is blank to switch the
power back on again.
After the printer starts up, it switches to Non-
Genuine mode.
Consumables Menu
Serial Number
Consumables Menu
Non-Genuine
Non-Genuine
•
Off
Non-Genuine
On
Press OK
to confirm
Switch power OFF
and then ON
Ready to print
Non-Genuine