Extreme Networks EPICenter 4.1, Software Installation Manual

Page: 452 / 546

452 EPICenter Software Installation and User Guide
The ACL Viewer
Figure 228: Setting up Cisco device policy
The initial values displayed either read from the switch, or are default values determined by the
EPICenter server.
6 To change the Starting Access List, Custom Queue List, or Priority Queue List, type or select a new
value in the appropriate field. The values you can use for these are as follows:
• Starting Access List : The EPICenter Policy Manager uses ten consecutive access lists to specify
traffic on a Cisco device. You can specify the starting access list, and EPICenter will use that list
plus the following five. For example, if you specify 100, then EPICenter will use access lists 100
through 109.
You can specify a starting access list between 100 and 190.
• Custom Queue List : You may specify a custom queue list for the EPICenter software to use to
apply policies that do bandwidth control. You can select a custom queue list from 1 to 16 from
the drop-down menu provided. The setting Don’t use indicates that no custom queue list is
configured on the device.
• Priority Queue List : You can specify a priority queue list for the EPICenter software to use to
apply policies that do priority control. You can select a priority queue list from 1 to 16 from the
drop-down menu provided. The setting Don’t use indicates that no priority queue list is
configured on the device.
7 For each interface to which the EPICenter Policy Manager will apply policies, select the interface in
the Interface list, and select a queueing strategy from the drop-down list in the Queueing Strategy
field.
• Select custom queuing to bind the custom queue you have selected to the interface, so the Policy
Manager can do bandwidth control on this interface.
• Select priority queueing to bind the priority queue you have selected to the interface, so the
Policy Manager can do priority control on this interface.