Dionex As, Operator'S Manual

Page: 296 / 356

AS Autosampler Operator’s Manual
284
Doc. 065051-03 1/08
Section 2.7.2 ). When the wait is the first sample prep step, samples are
run sequentially (see Section 2.7.3 ).
Changing the Position of the Wait Operation in the Sample Prep
Phase
•
To insert a step above the wait line, position the cursor on the wait
line and press the
Insert
button.
•
To insert a step below the wait line, position the cursor on the blank
line below wait and press the
Insert
button.
Enabling and Disabling the Wait Operation
1. If you are editing a method, save the current settings (see
Section D.5.2 ).
2. Go to the
MODULE SETUP
menu and press
5
to go to the
SYSTEM
PARAMETERS
screen.
3. Position the cursor in the
WAIT
field and press
Select
Δ
or Select
∇ to
select
ENABLED
or
DISABLED
.
4. Press
Enter
.
Specifying a Delay Between Prep Steps
The
DELAY
operation specifies the number of minutes the AS waits before
proceeding to the next step in the sample prep phase.
Number of Minutes to Delay
Before Performing Next Step
min DELAY 0.0
Delay Time
0.0 to 999.9 min