![background image](http://html1.mh-extra.com/html/conair/trueblend-sb-4/trueblend-sb-4_user-manual_2649035099.webp)
O p e r a t i o n l
4 - 6 1
4
Opera
tion
S e t u p S c r e e n s
( c o n t i n u e d )
The basic component alarm settings are:
Advanced
: This button will present a popup window where additional less frequently used
parameters can be set.
The advanced component control settings are:
Parameter
Default
Range
Security Description
Quantity of Incorrect Feeds
Before Alarm
5
[1:10]
Service
The number of bad gate feeds before a Material Feed
Error alarm is generated. A bad feed occurs when the
amount of material fed varies from the average by more
than the Max Feed Error Percentage.
Maximum Feed Error
Percentage (%)
50
[0.01:100] Setup
Should the material feed deviate by more than this per-
centage, a Material Feed Error alarm will be triggered
after the incorrect feed counter expires.
Quantity of No Material
Feeds Before Out of
Material Alarm
5
[0:100]
Setup
The number of gate feeds less than the “Minimum Feed
Weight” allowed before an ‘Out of Material’ alarm is
generated.
Minimum Feed Weight (g)
0.1
[0.1:0.999
]
Service
Minimum amount of weight fed before an out of mate-
rial condition occurs. Also used to determine if the min-
imum gate time is too low, thereby adjusting the feed
table.
Quantity of Out of Spec
Errors Before Alarm
5
[1:10]
Setup
The number of out of specification errors allowed
before generating an alarm. An out of specification
error occurs when the difference between the set and
actual % varies by more than the out of specification
percentage of the set %. (set%- act%)/set% > Out of
Spec% = Alarm condition..
Out of Specification (%)
5
[0:100]
Setup
Alarm if rate deviates more than this percentage value.
Parameter
Default Range
Security Description
Clear Gate Calibration
After Out of Spec
No
Yes/No Service
Will the gate feed table be cleared after an out of specification
condition.
Enable Material Level
Checking
No
Yes/No Setup
Enable the material level sensor for the selected hopper.
Additional hardware is required. Setting will not appear until
Material Level Sensing Enabled.
(Continued)
Summary of Contents for TrueBlend SB-4
