![background image](http://html1.mh-extra.com/html/conair/trueblend-sb-4/trueblend-sb-4_user-manual_2649035127.webp)
O p e r a t i o n l
4 - 8 9
4
Opera
tion
S e t u p S c r e e n s
( c o n t i n u e d )
The system should now be properly configured. The loading monitor screens can be refer-
enced to see the status of the loading process and communications.
1
From the <Home> screen press the [Loading] button.
This will present a screen that
shows the status of the loading system.
2
For the blender without the pump, there should be a small green box near each
loader body graphic.
This box should be colored green and contain the NodeID number
of the system with the pump (2). If this box is colored red, then communications
between the two systems is not working.
3
The loader bodies can also be independently enabled and disabled (ON/OFF) from
this screen.
4
Load and alarm times for each loader body can be set in setup, or from the monitor
screen for the loader body.
D i a g n o s t i c s
The diagnostics screens are used for diagnosing system control and hardware operations,
and only trained service personnel should use this area. The user must have {Service} level
security to enter diagnostics. To navigate to the <Diagnostic> screens, first navigate to the
<Home> page. At the <Home> screen press the [More...] button. Press the button labeled
[Setup] and the screen will change to the main <Setup> screen. Press the [Diagnostic] but-
ton in the lower right corner of the screen to show the initial screen <X20 PLC> diagnos-
tics.
The diagnostic screens are organized similar in concept to the Setup area. This is to group
the diagnostic functions by the type of device (X20 PLC, Batch Hopper, and Component).
The various device types are chosen by ‘Selection’ buttons shown across the TOP of the
screen. For each device, relevant parameters are further grouped into sections. Each section
is chosen using ‘Selection’ buttons along the Left side of the screen. With this method it is
very easy to navigate through-out the diagnostics area with a minimal amount of screen
navigation and user interaction.
NOTE:
Press the [Setup] button in the lower right corner of the screen to return to <Setup>.
✐
NOTE:
The [Home] button will return to the main <Home> screen.
✐
(Continued)
Summary of Contents for TrueBlend SB-4
