![background image](http://html1.mh-extra.com/html/conair/trueblend-sb-4/trueblend-sb-4_user-manual_2649035148.webp)
5 - 1 4
l M a i n t e n a n c e
L o a d C e l l R e m o v a l
( M o d e l s T B 2 5 0 , T B 5 0 0 ,
T B 9 0 0 )
1
Remove the weigh bin.
2
Disconnect the wiring that extends into the control box (see wiring diagram).
3
Look at the general location of all items to see how the items are installed before
removing.
4
Remove the load cell cover plate [7] by loosening the load cell cover plate holding
nuts [4] and sliding the cover upward off of the studs.
5
Unscrew the two hex nuts [2]
and [3] and remove the two
hex bolts [5] from the load cell.
6
Remove the weigh bin hanger
[6].
7
Remove the two screws that
mount the load cell to the load
cell mounting bracket [11] and
remove the old cell.
✒
Tip
: There is no need to remove the stop screw [9] and lock nut [10] during removal of the load cell.
It should remain in place so no adjustment is needed after installation.
W A R N I N G : E l e c t r i c S h o c k
High voltages can cause life-threatening currents in the body and injury from elec-
tric shock. Allow only trained and qualified electrical technicians to work on the
electrical system. Before any electrical work, disconnect the unit from the power
supply and lock to prevent unauthorized persons switching it on.
Do NOT use excessive force. Forces that are exerted on the load cell from outside
when attaching and removing the weigh bin load cell may damage the very sensi-
tive load cell.
Summary of Contents for TrueBlend SB-4
