![background image](http://html1.mh-extra.com/html/conair/trueblend-sb-4/trueblend-sb-4_user-manual_2649035130.webp)
4 - 9 2
l O p e r a t i o n
S e t u p S c r e e n s
( c o n t i n u e d )
Slice Detail - Connections
If the PLC IS NOT in (Test Mode / Automatic) mode, touching the slice graphic, or the slice
<Type> button, a detail view of the slice is presented. This detail view shows a graphic
image of the slice along with descriptive text for each connection point of the slice. The sta-
tus of any Inputs/Outputs will also be shown.
Manual PLC OFF:
This ‘Selection’ button can place the PLC into manual or automatic
mode. In automatic/off mode the system software will be in control of the PLC rack. A sta-
tus indication in the status bar at the bottom of the screen will indicate the PLC is in ‘PLC
Automatic’.
Slice Detail – Manual Control
If the PLC is in (Test Mode / Manual) mode, touching the slice graphic, or the slice <Type>
button, a detail view of the slice is presented. The status of any Inputs/Outputs will also be
shown. In this mode the descriptive text for the wire connections is not shown; instead man-
ual control buttons and data input fields are presented where applicable.
Upon leaving the X20 diagnostic screens, the PLC will always be removed from Test Mode.
Manual PLC ON:
This ‘Selection’ button can place the PLC into manual or automatic
mode. In manual/on mode the user will be in control of the PLC rack. A status indication in
the status bar at the bottom of the screen will indicate the PLC is in ‘PLC Automatic’.
IMPORTANT:
This will allow for manual control of the PLC. TAKE CARE WHEN
OPERATING IN TEST MODE! This mode should only be done by trained service
personnel. Injury or damage could occur without proper caution.
(Continued)
Summary of Contents for TrueBlend SB-4
