![background image](http://html1.mh-extra.com/html/conair/trueblend-sb-4/trueblend-sb-4_user-manual_2649035031.webp)
I n s t a l l a t i o n l
3 - 3
3
Installa
tion
P r e p a r i n g f o r I n s t a l l a t i o n
The TrueBlend Blender is easy to install if you plan the location and prepare the mounting
area properly.
1
Make sure the mounting area provides:
❒
A grounded power source supplying the voltage and correct current
for your
model. Check the blender’s serial tag for the correct amps, voltage, phase, and cycles.
Any field wiring should be completed by qualified personnel to the planned location
for the blender. All electrical wiring should comply with your region’s electrical codes.
❒
Clearance for safe operation and maintenance.
❒
A compressed air supply
. It is necessary to supply compressed air to the
blender. Your plant system must be capable of supplying at least 0.6 MPa (87 psi)
{6.0 bar}.
Note
: No additional compressed air consumers may be connected to the unit, because this may
reduce operating pressure. If the operating pressure is less than 0.6 MPa (87 psi) {6.0 bar}
the loading precision may be affected.
✐
Note
: Electrical supply must be a clean power source with nothing else on the circuit (for example
self-loading loaders.) The unit must be grounded to a lug by the sensor on the back of the
unit.
✐
Summary of Contents for TrueBlend SB-4
