![background image](http://html1.mh-extra.com/html/conair/trueblend-sb-4/trueblend-sb-4_user-manual_2649035044.webp)
4 - 6
l O p e r a t i o n
To u c h P a n e l I n t e r f a c e
( c o n t i n u e d )
Screen Navigation
Screen navigation is accomplished by pressing buttons visible on the command bars shown
at the right hand side of the screen. Each button appears as a raised area and is represented
with a name, an icon, or both an icon and name. When the button is pressed it will change
color and appear to be depressed. Note that on some screens it may not be possible to show
all navigation buttons at the same time. In these cases, the lower right hand side of the
screen will show a ‘More…’ button which will scroll through additional navigation buttons.
An example of a command bar:
The buttons present on the command bars will change based on which page is currently
being shown. Navigation buttons with identical function will be located in the same area on
numerous pages. For example, [Back] and [Home] buttons will be in the lower right corner
when applicable.
Selection buttons are buttons that represent a selected / not selected state. When NOT
selected these buttons appear raised with a gray face. When selected, this button will appear
sunken and have a dark green face. This button type is commonly found in ‘Reports’,
‘Setup’, and ‘Help’ areas of the system. They are used to select a type of Report, an area of
the Setup system, or a specific Help document.
Basic Navigation Buttons
There are several navigation buttons that are not specific to any page. The following section
outlines these buttons.
More
– This button is used to scroll through the various navigation / command buttons on
the screen.
Alarm
– This button is used to change the current screen to the ‘Active Alarms’
screen. This button will also change color to reflect the level of the alarm highest
active alarm. Refer to the Operation section entitled, Menus-Alarms for detailed
descriptions and alarms processing.
Back
– This button is used to return to the screen previously shown to the current
screen.
Home
– This button is used to return to the main screen of the system.
Yes
– Affirmative response to question, perform the action.
No
– Negative response to question, cancel the action.
NOTE:
If the button face appears as dark brown, then that button is ‘locked’ and will not function.
This is due to the current operating security level or the current operating state of the sys-
tem. Pressing a button in the locked condition will present the security popup window to
allow the user to enter a pass-code which will raise the operating security level to a high-
er level. This will allow the button to become ‘un-locked’.
✐
(Continued)
Summary of Contents for TrueBlend SB-4
