![background image](http://html1.mh-extra.com/html/conair/trueblend-sb-4/trueblend-sb-4_user-manual_2649035146.webp)
5 - 1 2
l M a i n t e n a n c e
W e i g h B i n M o u n t I n s t a l l a t i o n a n d
A d j u s t m e n t
( M o d e l s T B 0 4 5 & T B 1 0 0 )
Follow these steps to install and adjust the weigh bin and/or the weigh bin mount on
TrueBlend models TB45 and TB100. Use this procedure to fit a new weigh bin mount to an
existing weigh bin or to adjust the clearance between the weigh bin and the weigh bin
mount.
1
Remove the weigh bin from blender and set aside.
Push down on the thumb level
and pull the weigh pan straight out to remove.
2
Remove the three nuts and one button head bolt
that secure the weigh bin mount to
the load cell.
3
Set the weigh bin mount aside.
4
Adjust, or replace if necessary, the load cell so that the weigh bin mount, and the
weigh pan sit centered in the blender chassis,
unobstructed and not touching either
side.
5
Once the load cell is adjusted correctly, reinstall the weigh bin mount
to the load
cell, using the three nuts and one button head bolt to secure it. Adjust the bracket until it
is perpendicular to the load cell.
6
Torqueing the nuts and bolts the should be done very carefully,
to 10Nm {88 in-
lbs}.
7
Replace the weigh pan by holding down the thumb lever and carefully sliding the
pan straight into the blender,
with the top of the pan aligned with the guides in the
blender opening. Releasing the thumb lever should allow the pan to secure to the pins at
the back of the blender. If the pan does not feel secure, remove it and try again.
8
Calibrate/re-zero the load cell
as described in
the Operation section entitled, Menus-
Hopper setup
.
Summary of Contents for TrueBlend SB-4
