![background image](http://html1.mh-extra.com/html/conair/trueblend-sb-4/trueblend-sb-4_user-manual_2649035081.webp)
O p e r a t i o n l
4 - 4 3
4
Opera
tion
O p e r a t i n g S c r e e n s
( c o n t i n u e d )
Loaders
This page shows the status of a single loader and the pump in the system. An image for the
loader will display the current state of the loader, (Disabled, Enabled, Requesting, Loading,
and Dumping).
In addition to the loader status image, an alarm indicator will appear in the lower left corner
of the image, if the current loader body is currently alarming.
If the loader body requires a pump not connected with the current blender, a status indicator
will appear in the lower right corner of the image. The status indicator will be green if com-
munications to the remote pump is good or red if communications have failed. In addition,
the remote pump address will be shown with the indicator.
Settings
Editable values for loading, and alarm times can be configured on this page. These values
can also be found in setup.
•
Load Time (sec):
<10> [2 / 180] {Operator} The amount of time the loader body will
actively load material.
•
Alarm Time (sec):
<120> [0 / 3600] {Operator} This is the amount of time the hopper
will be loaded (after the first fill time) without the demand being satisfied before an
alarm will be generated.
•
First Fill Time (sec):
<5> [2 / 180] {Operator} This time allows an empty loader to be
filled for a designated time period before an alarm will be generated. The time starts
when the loader is turned on.
Blower
An image for the pump will display the current state of the pump (Disabled, Enabled,
Running, and Idling). A button below the pump will navigate to a page where further infor-
mation regarding the pump can be found.
Diagnostics
Simple diagnostic information is provided for each loader body which indicates the number
of loads, the total load time, the total discharge time for the loader body. These values can be
cleared by pressing the [Clear] button.
Clear
: Delete the diagnostic data for the selected loader.
(Continued)
Summary of Contents for TrueBlend SB-4
