![background image](http://html1.mh-extra.com/html/conair/trueblend-sb-4/trueblend-sb-4_user-manual_2649035111.webp)
O p e r a t i o n l
4 - 7 3
4
Opera
tion
S e t u p S c r e e n s
( c o n t i n u e d )
Serial Protocol:
The system has the capability of implementing the Modbus Serial and Allen Bradly DF1
protocols over a standard RS485 serial port. The serial port hardware is required for these
protocols which is not standard equipment. Only one protocol at a time may use the avail-
able serial port. The Modbus serial protocol does not require an unlock code to enable. This
section will allow for the configuration of the serial port and enabling of the protocol.
Contact a Conair sales or service representative for further information.
In order to set up a serial protocol, the port where the protocol will reside must first be cho-
sen. Once a serial port has been chosen, the remaining parameters will populate according-
ly.
The basic serial port settings are:
Parameter
Default Range
Security
Description
Protocol
None
Modbus/AB DFI
Service/Stop Select the appropriate protocol for the port. The
Modbus protocol does not require an unlock code,
while the ABDF1 protocol will require an unlock code.
Baud Rate
19200
800/9600/19200/38400/
57600/115200
Service/Stop Baud rate for the serial port.
Parity
None
None/Even/Odd
Service/Stop The Ethernet TCP/IP gateway address if required.
Stop Bits
1
1/2
Service/Stop Number of stop bits defined for the port.
Bits per
Character
8
7/8
Service/Stop Number of data bits per character.
(Continued)
Summary of Contents for TrueBlend SB-4
