![background image](http://html1.mh-extra.com/html/conair/trueblend-sb-4/trueblend-sb-4_user-manual_2649035120.webp)
S e t u p S c r e e n s
( c o n t i n u e d )
Manual Control
This mode allows the operator to control the component gates valves, the batch hopper
dump valve, the alarm claxon, the alarm beacon, the mixing chamber motor, and the mixing
chamber dump valve outputs manually. This is useful for testing the various PLC outputs or
if the operator wishes to clean out the system.
Manual control
: {Operator / Stop} The system must be stopped before Manual Control
can be entered. Selection buttons are provided for each output to open/close or enable/dis-
able each signal. When the button is pressed (selected state) the respective output will be
enabled.
The security level required to operate the blender manually can be uniquely configured on
the system security setup screen.
Disabled
: This is toggle button for controlling a digital output that is NOT controlling a
solenoid device. The button indicates the output is disabled.
Enabled
: This is toggle button for controlling a digital output that is NOT controlling a
solenoid device. The button indicates the output is enabled.
Close
: This is toggle button for controlling a digital output that is controlling a solenoid
device. The button indicates the output is disabled and the solenoid / gate is in the closed
state.
Open
: This is toggle button for controlling a digital output that is controlling a solenoid
device. The button indicates the output is disabled and the solenoid / gate is in the closed
state.
4 - 8 2
l O p e r a t i o n
(Continued)
Summary of Contents for TrueBlend SB-4
