![background image](http://html1.mh-extra.com/html/conair/trueblend-sb-4/trueblend-sb-4_user-manual_2649035164.webp)
C - 1
l A p p e n d i x
B l o w O f f I n s t a l l a t i o n I n s t r u c t i o n S h e e t
1
Mark your location of hole that will need to be drilled and tapped
(see the illus-
tration on the next page for your particular blender size).
2
Remove the level sensor (noting location of adjustment and sensor face), mixing
chamber front plate, mixing chamber, mixer, and any wiring that is in the way
of drilling the hole.
3
Drill a pilot hole at indicated location.
4
Drill 11/32” hole (de-burr hole) and tap 1/8” NPT.
Do not run tap fully through
the chassis. Clean all shavings and fines from the chassis.
5
Install item 8 into tapped hole and tighten.
6
Slide item 1 into item 8 through the mixing chamber
(this may be necessary
because of welded end). Do not tighten yet.
7
Install item 7 onto end of item 1 and tighten.
8
Remove air inlet to regulator and install item 2,3,4, and 5 and tighten.
(Use
thread tape where needed.) If the compressed air quality is poor and has contami-
nants in it the fitting should be installed on the outlet side of the regulator. The illus-
tration shows recommended placement of the items, but they can be installed as nec-
essary.
9
Route item 6 between item 5 and 7 and insert.
10
Re-install sensor and wiring.
11
Make any adjustments necessary.
Adjust flow through item 2 so a small amount of
air is bleeding from the opening in item 1. Adjust the insertion level and direction of
item 1 so the air is blowing across the face of the sensor. Insertion depth into the
chamber should be minimal as possible so tube does not contact mixer blade - tighten
item 8 on item 1.
NOTE:
The air should be
adjusted so fines are
cleaned away from the
sensor but the airflow
should not blow material
completely away, which
may cause a false empty
situation.
✐
The blow off kit is
available from
Conair.
(Part #
61126101)
Contact Conair Parts
1 800 458 1960
From outside of the
United States, call:
814 437 6861
Summary of Contents for TrueBlend SB-4
