![background image](http://html1.mh-extra.com/html/conair/trueblend-sb-4/trueblend-sb-4_user-manual_2649035051.webp)
O p e r a t i o n l
4 - 1 3
4
Opera
tion
O p e r a t i n g S c r e e n s
( c o n t i n u e d )
Pressing a locked field will present a popup window where a new security level passcode
may be entered. Touching the status area of the screen around the security indication will
launch the security entry popup. It is also possible to display the security screen popup from
the <Home> screen command bar by pressing [More…] – [Security].
With the security popup window displayed, a new passcode can be entered. If the passcode
is valid, the new security level will be set and the popup will close automatically after a
short timeout. If the new security level is high enough, data entry may resume. The popup
window can be dismissed by pressing the [Back] button. Pressing the [Lock] button will
automatically set the Guest security level and close the popup, without entering a passcode.
The security level, color, and default pass-codes are as follows:
•
0 – Green -
Guest
– minimum security level - This is the minimum security level. At
Guest level all screens are navigable; however data entry or system operational control
is locked. This allows a Guest to traverse the system but not make any changes.
•
1 – Yellow -
Operator
– Passcode ‘3333’ - With this level all blender operational
fields may be accessed.
•
2 – Orange -
Setup
– Passcode ‘2222’ - This level of security allows for various
blender setup parameters to be adjusted. Upon returning to the <Home> screen the
new setup parameters will be saved.
•
3 – Red -
Service
– maximum security level - Passcode ‘1111’ - The highest level of
security, this level is intended for Conair service personnel or those users who have
special training of the blender operation.
The pass-codes for each level can be changed in the ‘Setup’ – ‘Panel’ – ‘Security’
screen.
Refer to the Operation section entitled
,
Menus-Security
for more information
regarding user-defined passcodes and setting up the security system.
Also available with the security system is an ‘Auto Logout’ feature. If the ‘Auto Logout
Timeout’ value is set to a value other than 0, then after the set timeout value has elapsed,
the current security level number will be set to the minimum level (Guest).
Lock
– Set the security level to the minimum value without entering a passcode. Close the
security popup window.
NOTE:
If the passcode entered is invalid, the security level will be set to the minimum level.
✐
NOTE:
Some user interactions are also not possible if the blending system is operating or a set IO
condition exists. In these cases the fields will again be locked, however when touched, a
popup will be presented indicating the system must be Paused in order to perform the
necessary action. Pressing the [Back] button will dismiss the popup.
✐
(Continued)
Summary of Contents for TrueBlend SB-4
