![background image](http://html1.mh-extra.com/html/conair/trueblend-sb-4/trueblend-sb-4_user-manual_2649035106.webp)
4 - 6 8
l O p e r a t i o n
S e t u p S c r e e n s
( c o n t i n u e d )
The basic mixer control settings are:
Alarm Settings
This page is for setting up alarm parameters relevant to the mixing device.
The basic mixer alarm settings are:
Parameter
Default Range
Security Description
Mix Time
(sec)
10
[0:60]
Setup
The amount of time the mixer motor runs to blend the
material after the batch hopper empties.
Maximum
Dump Time
(sec)
5
[0:60]
Setup
The amount of time the mixer motor runs to blend the
material after the batch hopper empties The maximum
amount of time the mixing chamber will dump material.
Mixer Idle
Time (sec)
60
[0:9999]
Setup
The amount of time the mixer motor runs to blend the
material after the batch hopper empties The amount of
time the mixer motor will remain idle before the mix is
stirred. The mix motor will then run for several seconds.
Idle Mix
Time (sec)
3
[0:9999]
Setup
The amount of time the mixer motor runs to blend the
material after the batch hopper empties The amount of
time in seconds the mixer motor will mix if the batch
was not dumped after the last mixing.
Material
Request
Source
Mixer
Sensor
Mixer Sensor/
External/
Extruder Hopper/
Remote Extruder Hopper
Setup
The amount of time the mixer motor runs to blend the
material after the batch hopper empties. This is a menu
of options for where the request for material from the
mixer comes from.
Parameter Default
Range
Security Description
Mixer Not
Dumping
Time (sec)
0
[0:60]
Setup
If the mixer proximity sensor remains covered longer than this set time, an
alarm will be triggered. This condition is only tested while the blender is
in automatic. If the blender is stopped, this condition is not tested. If this
value is set to 0, the default, the alarm will not be triggered.
(Continued)
Summary of Contents for TrueBlend SB-4
