![background image](http://html1.mh-extra.com/html/conair/trueblend-sb-4/trueblend-sb-4_user-manual_2649035009.webp)
AT T E N T I O N :
R e a d T h i s S o N o O n e G e t s H u r t
We design equipment with the user’s safety in mind. You can avoid the potential hazards
identified on this machine by following the procedures outlined below and elsewhere in the
User Guide.
I n t r o d u c t i o n l
1 - 3
1
Introduction
W A R N I N G : I m p r o p e r i n s t a l l a t i o n , o p e r a t i o n , o r s e r v i c -
i n g m a y r e s u l t i n e q u i p m e n t d a m a g e o r p e r s o n a l
i n j u r y.
This equipment should be installed, adjusted, and serviced by qualified technical
personnel who are familiar with the construction, operation, and potential hazards
of this type of machine.
All wiring, disconnects, and fuses should be installed by qualified electrical techni-
cians in accordance with electrical codes in your region. Always maintain a safe
ground. Do not operate the equipment at power levels other than what is specified
on the machine serial tag and data plate.
W A R N I N G : V o l t a g e h a z a r d
This equipment is powered by single-phase alternating current, as specified on
the machine serial tag and data plate.
A properly sized conductive ground wire from the incoming power supply must be
connected to the chassis ground terminal inside the electrical enclosure. Improper
grounding can result in severe personal injury and erratic machine operation. (120
Volt units come with a grounded plug. Must be plugged into a grounded out.)
Always disconnect and lock out the incoming main power source before opening
the electrical enclosure or performing non-standard operating procedures, such as
routine maintenance. Only qualified personnel should perform troubleshooting pro-
cedures that require access to the electrical enclosure while power is on.
C A U T I O N : M i x b l a d e h a z a r d
There are two hazards associated with the mix blades. First, the blades are driven
with substantial torque. Never place your hand in the mix chamber unless power
is completely disconnected. Second, the mix blades may become razor sharp.
Always be careful when touching or cleaning these blades. Check for sharp edges
frequently. Replace blade if a hazard exists.
C A U T I O N : V e r t i c a l v a l v e h a z a r d
Vertical valves in hoppers slam closed without warning. They will injure your fin-
gers. Always keep fingers clear of valve openings. Never use your fingers to clear
an obstruction. Never use your fingers to move a sticking valve.
(Continued)
Summary of Contents for TrueBlend SB-4
