![background image](http://html1.mh-extra.com/html/conair/trueblend-sb-4/trueblend-sb-4_user-manual_2649035100.webp)
4 - 6 2
l O p e r a t i o n
( C o n t i n u e d )
S e t u p S c r e e n s
( c o n t i n u e d )
B a t c h H o p p e r
The Batch Weigh Hopper setup screens are used to set parameters that are relevant to the
weigh hopper. Settings are further grouped into categories: Control Parameters, Alarms,
and Calibration. The batch hopper is a central hopper mounted on a strain gauge where the
material is fed to form a (batch). Material is fed into the batch one at a time according to
the parameters defined by the recipe. When the batch is complete the hopper will dump the
material into the mixing chamber below, if the mixer is requesting material.
Batch Hopper Device Sections
Control
: This page is for setting up control settings for the gate feeder hopper.
Alarm:
This screen sets parameters which control when a component alarm might occur.
Calibrate
: This screen will allow the weight calibration settings to be edited; or the weight
calibration procedure can be followed to determine the appropriate settings.
(Continued)
Summary of Contents for TrueBlend SB-4
