User Manual_POE60S-4AF
Power over Ethernet Midspan
POE60S-4AF User Manual
BERGER Stromversorgungen GmbH & Co. KG
Am Eiskellerwald 22
77855 Achern
Germany
www.berger-stromversorgungen.de
Tel.: +49 (0)7841-67304-0
Fax: +49 (0)7841-67304-29
POE60S-4AF User Manual
Power over Ethernet and Data Extender
Power over Ethernet has a range of about 100 meters
from the network switch or midspan. Should PoE be
needed at distances greater than 100 meters, solutions
might include rewiring and moving network midspans,
all of which may require extensive labor and may be
costly. Phihong has developed a more cost effective
option with the POE60S-4AF. Users can double the
effective PoE Range of their devices to 200 meters.
Using standard RJ45 connecting Ethernet cables the
POE60S-1AF takes its power from an Ultra or Mega PoE
midspan (75W or greater). The output is converted to
be IEEE802.3af compatible 15.4W per port. The device
can also act as a switchdata repeater by itself. It has
an optional 75W DC power adapter, the PSC75U-560
which can power all four ports at 15.4W per port.
This extender makes espanding a network easy. The
POE60S-4AF makes it possible to add an additional 4
security cameras 200 meters from a network switch. The
fi rst Ethernet cable not exceeding 100 meters should be
laid from the switch to a midpoint where the POE60S-
1AF is connected; additional cables not exceeding 100
meters each should run from the extender to the security
cameras. As this device is built with plug-and-play
technology there is no additional software or hardware
installation required. Upon powering up, the device
will work automatically taking the necessary power
from the midspan and relaying it on to the IEEE802.3af
compatible device.
Compatible IEEE802.3af devices include but are not
limited to Security Cameras, IP Telephones, and wireless
network and access controllers.
Installation Sequence:
1) Using the appropriate Ethernet cable, Category
5e or above, connect the PoE In/WLAN to the
Ultra PoE(75W) (POE OUT) in the midspan
communications cabinet.
2) Using the same type of cable as before, connect
the “Power Out” to the given devices, i.e. security
cameras.
3) Wait a few seconds to allow for connectivity
Data (IN/OUT)
Full Duplex - Solid Green
Half Duplex - Off
Blinking LED indicates fault
100M - Solid Green
10M - Off
Ethernet activity - Yellow blinking
PoE Input
On: Input power OK
Off: No power or voltage low
PoE Output
(per port)
On: POE output OK
Off: No POE output
Should any fault occur with the connection, the LED’s
will indicate as per the direction above.
Input Power
Phihong’s Ultra or Mega
Power (75W or better). or
equivalent or optional DC
power adapter
Output Power
4 ports at IEEE802.3af
standard: 15.4W per port for
62W total power
Ethernet Cable
Designed to operate with
Categories 5e or 6. All
cables must be the same
category for full functionality.
Dimensions
174x154x38mm
(6.85x6.06x1.5in)
Weight
0.9kg
(1.98lb)
Operating
Temperature
-40 to +60
°
C
-40 to +149
°
F
