162 • Schlage • ENGAGE Managed Property User's Guide
MT20
Installation and Commissioning
Fig. 11.83: Enroll New Credential
• The MT20 will momentarily flash
GREEN
while reading the credential data and will return to solid
RED
, waiting for the next credential enrollment presentation.
• If the MT20
does not respond
to a credential presentation, and the LED remains
RED
with no
beeps, the credential is not a valid credential type and is not supported.
7. Select
Save
• The newly added credential is now listed under “Credentials” for the selected User.
MT20 Output Formats
The MT20 default output format is “hexadecimal” for use with the ENGAGE system. There are
additional output formats available when necessary.
To change the MT20 output format, a configuration card is needed and must be presented to the
MT20 within 60 seconds after boot-up is completed.
• Default configuration card CE-401-073 required for ENGAGE (Hexadecimal)
• Configuration card CE-401-061 required for
Schlage Express
(Octal)
• Configuration card CE-401-060 required for FC/BID Output
• Configuration card CE-401-069 required for BID Only
Each of these Configuration cards are provided with the MT20 in the box.
Changing MT20 Output Formats
To change the MT20 output format configuration,
follow these steps.
1. Select
the desired output format Configuration
card. (In the box)
2. Power cycle the credential reader.
3. Present
the Configuration Card within the first
minute after power is applied (and Boot Up
completed) and after the MT20 boot-up process has completed
4. The MT20 will confirm the output configuration change with two short beeps and the LED will
flash
RED
.
5. The MT20 will then boot-up again and after boot-up is complete, the MT20 will be ready to
output the new output format.
• The MT20 red LED will remain ON solid waiting for a new credential presentation.
WARNING:
The reader will boot up
after power is applied. Be sure to wait
until the reader beeps three times before
presenting the Configuration Card or it
will not perform as intended.
