142 • Schlage • ENGAGE Managed Property User's Guide
NDE80 and NDEB ENGAGE Devices
Installation and Commissioning
NDE80 ONLY: Install the Magnet and Strike
Depending on the door frame requirements, ANSI and T-Strike DPS sensor options are available.
Install the provided standard DPS magnet or install the magnet tray along with the appropriate strike.
Note:
Î
ANSI Strikes with the Magnetic Tray are recommended. T-Strikes with a separate magnet is
provided as an alternate
.
When the T-Strike and standard door position magnet are used,
additional door prep is required to install the magnet into the frame.
WARNING:
The Door Position Sensor magnet tray or T-Strike magnet MUST be installed
for proper Door Position sensing and proper calibration during commissioning
Fig. 11.43: NDE80 Magnet and Strike options
Install the DPS sensor NDEB ONLY
When working with NDEB Wireless Locks, a separate
DPS magnet and standard wiring through the door to
the NDEB circuit board is required.
WARNING:
The Door Position
Sensor magnet MUST be installed
properly. Pay attention when connecting
(or removing) the cable the DPS cable
connector. This connector is very small
and can be easily damaged. Ensure the
DPS wires will not be pinched when the
battery holder and battery cover are fully
installed
