140 • Schlage • ENGAGE Managed Property User's Guide
NDE80 and NDEB ENGAGE Devices
Installation and Commissioning
NDE80 and NDEB ENGAGE Devices
Device Introduction
The installation instructions outlined here are excerpts from the devices’ Installation Instructions
in-the-box and cover the most common issues encountered when installing the device.
Before installing the device, review the Installation Instructions for the Schlage NDE80 and NDEB lock
contained within their respective boxes.
Note:
Î
NDE80 and NDEB locks have very similar installation requirements. NDEB locks will include
a standard magnetic DPS switch and will require additional installation door preparation.
NDE80 locks can be upgraded to NDEB with an upgrade kit
Prepare to Install the NDE80 or NDEB Wireless Locks
Before installing, record the serial number and the
intended (or installed) location. This information is
required for the Administrator to commission the
device and entry into the ENGAGE account.
1. Verify the door is properly prepared for the
Schlage NDE80 or NDEB installation before attempting to install.
• The Schlage NDE80/NDEB and the mechanical ND locks use the SAME basic door preparation
template, which comes in the box with the product.
• Mechanical cylindrical lock (ND) updates to NDE80 or NDEB are easily performed.
• Schlage NDEB locks will have additional DPS installation door preparation requirements
compared to mechanical ND and NDE80 locks.
2. Verify these
critical items
before attempting to install the Schlage NDE80 or NDEB.
• Through door bore backset = 2 or 2 inches
• Through door bore diameter = 2 inches
• The two 5/16 inch through door bolt holes are properly located
• Latch Bore hole diameter = 1.0 inch and the hole is centered in the door
• Latch bore hole centerline and the Door bore hole centerline is in alignment.
• For NDEB only:
• The additional DPS door edge and frame hole locations are made based on the door
material (wood/metal)
• The DPS wire routing hole on the face of the
door is on the
interior of the door
• The DPS wire routing hole is ONLY halfway
through the door
Tools Needed
:
Phillips screwdriver,
pin wrench, tape
measure
T-15 Torx screwdriver
(optional).
WARNING:
DO NOT USE A
POWER DRILL for installation. Power
tools may damage the product.
WARNING:
The Centerline of the
Latch Bore Hole and the Centerline of the
though Door Bore MUST be accurate for
proper latch retraction.
