108 • Schlage • ENGAGE Managed Property User's Guide
Reader Defaults
Web Application
Reader Defaults
Reader Default settings allow for the most common
credentials to be available when a device is new out
of the box or recently had a factory default reset
performed. It is most important for devices to be
operational for the broadest Construction Mode
credential acceptance ability before commissioning.
Each commissioned device will be programmed with
the defined reader default settings.
Note:
Î
Reader Default settings apply to LE, NDE, and Multi-Technology Reader product families.
The MT20 and MT20W credential enrollment readers will read any compatible credential
and therefore, do not have Reader Default settings.
1.
.
2. Select
Advanced
menu
then
Reader Defaults
tab.
3. Adjust as needed and
click
Save
.
Notice that as you
enable certain
settings, other
settings are disabled.
Some settings conflict
and therefore cannot
be enabled at the
same time.
WARNING:
Any setting changes or
updates made to an installed and
previously commissioned device will
require Sync.
Fig. 8.108: Advanced > Reader Defaults
Reader Sensitivity is
set to
Normal
by
default and is
recommended for
most properties. Use a
Reader Sensitivity of
High or Max to enable
a more reliable
reading of physically
smaller key fobs due
to smaller antenna.
For best reader
response and
improved battery life,
disable any credential
technology that is not
needed.
