Shibaura CA20-M10, Руководство по эксплуатации

Страница: 246 / 384

13
– 2

13.2 Method of mode setting
The mode should be set for the following items.
The power must be turned off and then on again after changing the value of 21. Setting of
DeviceNet. The power does not have to be turned off for other items.
1. Single operation mode input bit designation
2. Continuous start input bit designation
3. Escape input bit designation
4. Pause input bit designation
5. Program selection input bit designation
6. Return to origin input bit designation
7. Pausing output bit designation
8. Input wait output bit designation
9. Teach Pendant display language Japanese/English
10. OFF (Invalid), easy, point, pulse 1, pulse 2
11. Clear at general-purpose output reset Valid/Invalid
12. Status setting when continuous start is ON Hold/Clear
13. Status setting when continuous start is OFF Hold/Clear
14. Direct output designation
15. READY output bit designation
16. Palletizing input bit designation
17. Expansion I/O during point designation Valid/Invalid
18. Task positioning output designation
19. Task return to origin output designation
20. Setting of CC-Link
21. Setting of DeviceNet ------------------------ The power must be turned off and then on again
22. Designation of battery alarm output bit
23. Moving coordinate table number output in external point designation mode
Enter the PARA mode to set the mode. (Refer to section 13.1.)
STEP 1
When this display appears, press
F 1
.
STEP 2
Press
NEXT
or
-NEXT
to move to the M01 to
M23 mode setting screens.

Search function
When
SEARCH
is pressed and the parameter No. 1 to 23 is input, the mode setting screen
can be searched.
[ P A R A ] F 1 : S E T M O D E
F 2 : P A R A M E T E R 1
F 3 : P A R A M E T E R 2
F 4 : T A B L E
Parameter No.