Shibaura CA20-M10, Руководство по эксплуатации

Страница: 330 / 384

18
– 30
[Key operation]
Press
F 1
,
IN
1
and
TIM
6
.
NOP changes to MVE.
Press
ENT
.
STEP 2
Press
ALT
to select "a" (absolute coordinate)
or "i" (relative coordinate) and press
ENT
.
STEP 3
Enter the coordinate table No. with the numeric
keypad and press
ENT
.
(Input range: 0 to 999. 0: No designation.)
STEP 4
Use the numeric keypad to enter the counter
No., which designates the coordinate table No.
of the destination. Press
ENT
.
(Input range: 0 to 99. 0: No designation.)
STEP 5
Enter the speed table No. with the numeric
keypad and press
ENT
.
(Input range: 0 to 10.) When V = 0 is entered,
the speed is set to the designated speed preset
by SPD command.
NOTE

If neither STEP 3 nor STEP 4 or if both are designated, a "PARAMETER ERROR"
will occur when the command is executed. If the counter No. is designated in
STEP 3 and the counter details are "0", a "TABLE No. ERROR" will occur when
the command is executed.

For details of a (absolute coordinate position), i (relative coordinate position), refer
to "MOV System Command Words and Parameters" (section 3.2.4).
If the cursor is at STEP 2 to 5, press
F 1
to change to the coordinate table display
and set the coordinates. (Refer to section 13.5.1 on how to set the coordinate table.)
Press
ESC
to return to the original display.
[ P R G M ]
0 0 0 1 a S N O = 0 0 0
M V E V = 0 0 C N T [ 0 0 ]
P O S T
[ P R G M ]
0 0 0 1 a S N O = 0 0 0
M V E V = 0 0 C N T [ 0 0 ]
P O S T
[ P R G M ]
0 0 0 1
N O P
STEP 1