Shibaura CA20-M10, Руководство по эксплуатации

Страница: 194 / 384

11
– 4

11.1.5 Connection of exclusive CC-Link cable
The order of cable connection is unrelated to the station number.
Be sure to connect the terminators for the units located at both ends of the CC-Link system.
Connect each terminator between DA and DB.
In the CC-Link system, the terminator to be connected differs with the cable to be used.
Type of cable Terminator
CC-Link exclusive cable
110

, 1/2 W (Brown, brown, brown)
CC-Link exclusive cable designed for Ver 1.10
CC-Link exclusive high-performance cable 130

, 1/2 W (Brown, orange, brown)
No terminator is attached to this controller.
The master unit can be located at other than the both ends.
Star-connection is not possible.
The connecting method is shown below.
For details on the cable connection, see the master station instruction manual and CC-Link cable
wiring manual (published by the CC-Link Partner Association).

11.1.6 CC-Link settings
(1) CA20-M10-CC settings
The station number (MAC ID) and baud rate are specified by [PARA] M20 in the mode setting.
To enable a modified value, turn the power off and then on again. (Refer to section 13.2.20.)
(2) CC-Link master station settings
Make the CC-Link master station settings by following the master station operating manual.
The type of CA20
–M10–CC is the remote device station, and the number of exclusive stations
is four (4).
Terminator
Master unit
CC-Link
exclusive cable
Remote unit Local unit
Terminator
CC-Link
exclusive cable