Shibaura CA20-M10, Руководство по эксплуатации

Страница: 254 / 384

13
– 10

13.2.21 Setting of DeviceNet
Use the numeric keypad to enter the station
number, and press
ENT
.
Use
ALT
to select BAUD RATE, and press
ENT
.
Use the numeric keypad to enter the option flag
value, and press
ENT
.
When
NEXT
is pressed, the next screen will
display, and when
-NEXT
is pressed, the
previous screen will display. Press
ESC
to
return to the PARA mode screen.
●The power must be turned off and then on again after changing the value of this
parameter.
●The STATION option sets the DeviceNet unit station number.
(Initial value: 0, Setting range: 0 to 99)
●The BAUD RATE option sets the DeviceNet transmission speed. The settable
transmission speed varies depending on the total cable length and cable types.
(Initial value: 125K, Selection range: 125K, 250K, 500K)
●When the thousands place of the option value is set to "0", all system input and
general-purpose input from DeviceNet is enabled.
When "1" is set, system input and general-purpose input (ports 1 to 3) of the master
unit is enabled from the input/output connectors.
(Initial value: 0000, Setting range: 0000 to 9999)

13.2.22 Designation of battery alarm output bit
Use the numeric keypad to designate the output
bit and press
ENT
.
When
NEXT
is pressed, the next screen will
display, and when
-NEXT
is pressed, the
previous screen will display. Press
ESC
to
return to the PARA mode screen.
When the battery voltage drops, the bit designated for battery alarm output is set to
ON. (Refer to section 10.2.20.)

13.2.23 Moving coordinate table number output
in external point designation mode
This parameter is not available.
Press
-NEXT
to display the previous screen.
Press
ESC
to return to the PARA mode
screen.
[ P A R A ] M 2 3
E X . P O I N T D E S I G . M O D E
P O I N T T A B L E O U T P U T
[ O F F ]
[ P A R A ] M 2 2
B A T T E R Y
A L A R M O U T P U T
0 - 0 1 - 0
[ P A R A ] M 2 1
D e v i c e S T A T I O N : 0 1
N e t B A U D R A T E : 1 2 5 K
O P T I O N : 0 0 0 0
STEP 1
STEP 2
STEP 3
STEP 1
STEP 1