Mitsubishi Electric MR-J4-100A(-RJ), Инструкция по эксплуатации

Страница: 204 / 908

5. PARAMETERS
5 - 1
5. PARAMETERS
CAUTION
Never make a drastic adjustment or change to the parameter values as doing so
will make the operation unstable.
Do not change the parameter settings as described below. Doing so may cause
an unexpected condition, such as failing to start up the servo amplifier.
Changing the values of the parameters for manufacturer setting
Setting a value out of the range
Changing the fixed values in the digits of a parameter
POINT
The following parameters are not available with MR-J4-03A6(-RJ) servo
amplifiers.
[Pr. PA02 Regenerative option]
[Pr. PA17 Servo motor series setting]
[Pr. PA18 Servo motor type setting]
[Pr. PA26 Function selection A-5]
[Pr. PC44 Function selection C-9]
[Pr. PC45 Function selection C-A]
[Pr. PD47 Output device selection 7]
[Pr. PE03 Fully closed loop function selection 2]
[Pr. PE04 Fully closed loop control - Feedback pulse electronic gear 1 -
Numerator]
[Pr. PE05 Fully closed loop control - Feedback pulse electronic gear 1 -
Denominator]
[Pr. PE06 Fully closed loop control - Speed deviation error detection level]
[Pr. PE07 Fully closed loop control - Position deviation error detection level]
[Pr. PE08 Fully closed loop dual feedback filter]
[Pr. PE10 Fully closed loop function selection 3]
[Pr. PE34 Fully closed loop control - Feedback pulse electronic gear 2 -
Numerator]
[Pr. PE35 Fully closed loop control - Feedback pulse electronic gear 2 -
Denominator]
[Pr. PF25 SEMI-F47 function - Instantaneous power failure detection time]
[Pr. PF34 RS-422 communication function selection 3]
Linear servo motor/DD motor setting parameters ([Pr. PL_ _ ]) cannot be used
with MR-J4-03A6(-RJ) servo amplifiers.