Mitsubishi Electric MELDAS 600M Series, Инструкция по эксплуатации

Страница: 507 / 512

CHAPTER 4 APPENDICES
Appendix 4. Warning Messages
IV
– 65
4.9 Auxiliary axis operation warnings (AMW )
AMW0001 Aux axis operation error
No. Details Remedy
0001 Near-point
dog length
insufficient
When executing dog-type reference
point, the zero point return speed is
too fast or the dog length is too
short.
•
Lower the zero point return speed
or increase the dog length.
0003 Reference
point return
direction
illegal
When executing reference point
return, the axis was moved in the
opposite of the designated direction.
•
Move the axis in the correct
direction.
0004 External
interlock
The axis interlock function is valid.
•
Cancel the interlock signal
0005 Internal
interlock
An interlock was established by the
servo OFF function.
•
Cancel the servo OFF.
0007 Soft limit The soft limit was reached.
•
Check the soft limit setting and
machine position
0024 In absolute
position
alarm.
Reference
point return
not possible.
Reference point return was
executed during an absolute
position alarm.
•
Initialize the absolute position and
then fix the absolute position
coordinates.
0025 In initializing
absolute
position.
Reference
point return
not possible.
Reference point return was
executing while initializing the
absolute position.
•
Initialize the absolute position and
then fix the absolute position
coordinates.
AMW0002 Aux axis operation error
No. Details Remedy
0001 No operation
mode
The operation mode is not
designated, or the operation mode
was changed during axis
movement.
•
Correctly designate the operation
mode.
0003 Feedrate 0 The operation parameter's feedrate
setting is zero.
Or, the override is valid, and the
override value is zero.
•
Set a value other than zero in the
feedrate setting or override value.
0060 Station No.
designation
illegal.
Starting not
possible.
A station No. exceeding the No. of
indexed divisions was designated.
•
Correctly designate the station
No.
Downloaded from ManualsNet.com search engine