Mitsubishi Electric MELDAS 600M Series, Инструкция по эксплуатации

Страница: 208 / 512

CHAPTER 1 SCREEN OPERATIONS
3. Setup Screens
I
– 193
3.7.3 Carrying out width measurement
1)
The cursor appears at point A.
Using the
↑
and
↓
keys, move the cursor to points
A and B for each axis.
2)
The message "On meas" appears.
3)
4)
When the tool contacts the inner walls of the groove,
the skip position is displayed at the movement axis of
the point A measurement counter. The cursor moves to
point B. The cursor moves to point A when at point B.
5)
When the tool contacts the opposite side of the groove,
the skip position is displayed at the movement axis of
the point B measurement counter.
6)
7)
The width center is measured, and the value is set in
the workpiece coordinate offset G55 (coordinate
system selected in step 6).)
The measurement counter display becomes blank.
8)
9)
The message "On meas" disappears.
Press the menu
Width meas
.
Turn ON the measurement
switch on the machine
operation board.
Move the spindle into the
groove, using manual feed
and manual handle feed.
Put the tool in contact with the
inner walls of the groove.
Put the tool in contact with the
opposite side of the groove.
Select the workpiece
coordinate offset in which the
measurement data will be set.
(Example)
Press the menus
Coord G54-G59 G55 to
select G55.
Press the menu
Coord write
.
Carry out the operations in
steps 3) to 7) in the same way
for the Y and Z axes.
Turn OFF the measurement
switch.
Downloaded from ManualsNet.com search engine