CHAPTER 4 APPENDICES
Appendix 4. Warning Messages
IV
– 60
No. Message
Details
Remedy
OPW0123 Machining
time
calculate mode
Starting was attempted during
the machining time calculation
or during the machining time
calculation mode.
•
Wait for the machining time
calculation to complete, or restart
after canceling the machining time
calculation by resetting.
OPW0124 In
synchronous
correction mode
The synchronous correction
mode switch was turned ON in a
mode other than the handle
mode.
•
Select the handle mode.
•
Turn OFF the synchronous
correction mode switch.
OPW0125 In axis control
Starting is not possible because
the axis is already being
controlled.
•
Restart after stopping the axis
being controlled.
OPW0126 Acc/dec T cnst
pre-intrpl large
An internal interlock occurred
because the pre-interpolation
acceleration/deceleration time
constant is too large.
•
Reduce the command speed, or
reduce the parameter setting
value for the pre-interpolation
acceleration/deceleration time
constant.
OPW0127 In
emergency
stop
Starting was attempted during
an emergency stop.
•
Restart after canceling the
emergency stop.
OPW0128 In
absolute
position alarm
Starting was attempted during
an absolute position detection
alarm.
•
Start after canceling the absolute
position detection alarm.
OPW0129 In abs posn
initial setting
Starting was attempted during
zero point initialization of the
absolute position detection
system.
•
Start after the zero point
initialization is completed.
OPW0130 Tool life over
The tool life (No. of uses, time,
etc.) has reached the setting
value.
•
Replace the tool.
OPW0131 Overheat
The NC or operation board
temperature has risen above the
specified range.
•
Cooling measures are required.
Turn OFF the NC power, or lower
the temperature with an air
conditioner, etc.
OPW0132 Top search not
completed
A top search was not executed
before the restart search.
•
Execute a top search.
OPW0133 Restart
search
error
In internal error occurred during
the restart search.
•
Execute from the restart top
search after resetting.
OPW0134 Restart
search
completed
Another restart search was
attempted in the program restart
after the restart search was
completed.
•
If continuing the program restart
operation (automatically/manually
returning to the restart position),
restart is possible from the first
block searched.
•
If executing the search again, first
cancel the previous restart search
by resetting. Then execute a
restart search after executing a
top search.
Downloaded from
Содержание MELDAS 600M Series
