CHAPTER 1 SCREEN OPERATIONS
2. Monitor (Operation) Screens
I
– 71
: Valid for calculation : Special process : Invalid
Function
M code
Calcu-
lation
Group
Machining center format
I
(Standard format)
Machining center format
II
(M2/M0 format)
00
–
Program stop
Same as left
01
–
Optional stop
Same as left
02
–
Program end
Same as left
30
–
Program end
Same as left
96
–
Macro interrupt ON
I
ON
97
–
Macro interrupt cancel
I
OFF
98
– Subprogram
call
(G22)
99
– Subprogram
return
(G23)
* : Indicates the codes that should be selected or that are selected in the initial state.
**
: Codes that should be selected or that are selected in the initial state by the control parameters.
(Note 1)
The deceleration time in the exact stop check mode is not accumulated, so this causes an
error.
(Note 2)
If there is a program parameter input, check the parameter after calculation.
(Note 3)
The thread cutting mode is not cumulated.
(Note 4)
The automatic tool length measurement is not cumulated.
(Note 5)
The deceleration time in the exact stop check mode causes an error in the cumulated time.
(Note 6)
The corner deceleration time is not cumulated in the high accuracy control mode, so an error
occurs.
(Note 7)
Even with automatic corner override, the time is calculated by assuming a 100% override.
Thus, an error occurs.
Downloaded from
Содержание MELDAS 600M Series
